Feiss FM335 User Manual download pdf

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR

CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before assembly. Bulbs

not included.

1. Attach mounting bar securely to ceiling junction box with

two machine screws (supplied with junction box) through

slot at each end of mounting bar.

Note: mounting bar should be installed with "GND" imprint

and/or two dimples facing down.

2. A. Fasten one hex nut about 3/4" (19 mm) down from one

end of threaded pipe.

B. Then screw same end of threaded pipe into center hole in

mounting bar.

C. At this point test install the pan onto ceiling through this

threaded pipe and make certain 3/8" (10 mm) of pipe

protrude below. If not, then adjust the threaded pipe location

by screwing up or down accordingly. Once correct threaded

pipe location has been adjusted, remove pan and tighten hex

nut against mounting bar. Make certain not to spin threaded

pipe during tightening.

3. A. Spread the electrical wires so that the black wires are on

one side of the outlet box and the white wires are on the

other side.

B. Electrical connections:

Connect the white wire from the fixture to the white wire of

the outlet box. Connect the black wire from the fixture to

the black wire of the outlet box.

NOTE: Black outlet box wire may be red, round & smooth

and/or have copper conductor. White outlet box wire may be

square & ridged and/or have a silver conductor.

C. Grounding Connection:

Connect fixture ground wire (without insulation) to ground

wire from outlet box (usually with green insulation) with

wire connector (not provided).

IMPORTANT: Never connect ground wire to black or white

power supply wires.

4. Place pan through threaded pipe so that it sits flush against

ceiling. Be sure all wires are inside pan. Secure pan to ceiling

by fastening with a hex nut. Then fasten cap nut.

5. Install bulb (not included). See relamping label located at

socket area for type and maximum allowed wattage.

6. A. Slip glass plate inside of main frame and allow to sit at

bottom.

B. Slip and hold main frame against the installed pan, making

certain the three threaded screws in pan are aligned with the

three tabs inside of main frame.

C. While firmly holding onto main frame, lift and tilt glass

plate toward one side then insert hand to fasten with three

cap nuts. See fig. 2.

Assembly Instructions For

FM335

(E) 11/09

Fig. 2

Assembly Instructions For 1

Summary of Contents

Page 1 - Assembly Instructions For

IMPORTANTTURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOXBEFORE STARTING INSTALLATION Carefully unpack and identify all parts before assemb

Comments to this Manuals

No comments

Feiss FM335 User Manual

Browse online or download User Manual for Lighting Feiss FM335. Feiss FM335 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Feiss FM335